3Com Switch 4500 26-Port User Manual

AAA and RADIUS Protocol Configuration 209
However, the user-privilege level is a global value for all service types. Entering
the following two commands will result in the user having a level of 3 for all
service types. In this case both telnet and SSH:
[4500-SI-luser-adminpwd]service-type telnet level 1
[4500-SI-luser-adminpwd]service-type ssh level 3
You can use either level or service-type command to specify the level for a
local user. If both of these two commands are used, the latest configuration will
take effect.
Disconnecting a User by
Force
Sometimes it is necessary to disconnect a user or a category of users by force. The
system provides the following command to serve this purpose.
Perform the following configurations in System View.
Tab le 219 Disconnecting a User by Force
By default, no online user will be disconnected by force.
Configuring the RADIUS
Protocol
For the Switch 4500, the RADIUS protocol is configured on the per RADIUS
scheme basis. In a real networking environment, a RADIUS scheme can be an
independent RADIUS server or a set of primary/secondary RADIUS servers with the
same configuration but two different IP addresses. Accordingly, attributes of every
RADIUS scheme include IP addresses of primary and secondary servers, shared key
and RADIUS server type, etc.
RADIUS protocol configuration only defines some necessary parameters used for
information interaction between NAS and RADIUS Server. To make these
parameters effective, it is necessary to configure, in the view, an ISP domain to use
the RADIUS scheme and specify it to use RADIUS AAA schemes. For more
information about the configuration commands, refer to the AAA Configuration
section above.
RADIUS protocol configuration includes:
■ Creating/Deleting a RADIUS Scheme
■ Configuring RADIUS Authentication/ Authorization Servers
■ Configuring RADIUS Accounting Servers and the Related Attributes
■ Setting the RADIUS Packet Encryption Key
■ Setting Retransmission Times of RADIUS Request Packet
■ Setting the Supported Type of the RADIUS Server
■ Setting the RADIUS Server State
■ Setting the Username Format Transmitted to the RADIUS Server
Operation Command
Disconnect a user by
force
cut connection { all | access-type { dot1x | gcm |
mac-authentication } | domain domain_name |
interface interface_type interface_number | ip
ip_address | mac mac_address | radius-scheme
radius_scheme_name | vlan vlanid | ucibindex
ucib_index | user-name user_name }

3Com Switch 4500 26-Port Specifications

General

Brand	3Com
Model	Switch 4500 26-Port
Category	Switch
Language	English