Access Management Configuration 95
Enabling/Disabling Access Management Trap
You can enable the access management trap function using the following
commands. When this function is enabled, the trap information of access
management is delivered to the console for the purpose of monitoring.
Perform the following configuration in System View.
By default, the access management trap is disabled.
Displaying and
Debugging Access
Management
After the above configuration, enter the display command in any view to display
the current configurations of access management and port isolation information,
and to verify the effect of the configuration.
Access Management
Configuration Example
Networking Requirements
Organization 1 is connected to port 1 of the Switch, and organization 2 to port 2.
Ports 1 and 2 belong to the same VLAN. The IP addresses range 202.10.20.1 to
202.10.20.20 can be accessed from port 1 and the range 202.10.20.21 to
202.10.20.50 from the port 2. Organization 1 and organization 2 cannot
communicate with each other.
Networking Diagram
Figure 28 Networking Diagram for Port Isolation Configuration
Configuration Procedure
1 Enable access management globally.
[4500]am enable
Tab le 90 Enabling/Disabling Access Management Trap
Operation Command
Enable access management trap am trap enable
Disable access management trap undo am trap enable
Tab le 91 Displaying Current Configuration of Access Management
Operation Command
Display the status of access management
function and configuration of IP address pool
display am [ interface_list ]
Display port isolation information display isolate port
External
Network
E 0/1
E 0/2
To Next Page
Loading...
Need help?
General