326 CHAPTER 19: SSH TERMINAL SERVICES
Open an SSH Connection with Password
1 Click <Open>. The following SSH client interface appears. If the connection is
normal, you will be prompted to enter the username and password, as shown in
Figure 100.
Figure 100 SSH client interface
2 Enter the username and password to create an SSH connection.
3 To log out, enter the quit command.
Configuring the Device
as an SSH Client
Table 355 describes the tasks required to configure an SSH client.
Table 355 SSH client configuration
1 Starting the SSH client
Use this configuration task to enable the connection with the SSH client and the
server, and specify the preferred key exchange algorithm, encryption algorithm
and HMAC algorithm of the client and the server. Perform the following
configuration in system view.
No Configuration Item Command View Description
1 Set to perform the
first-time authentication
on the SSH server to be
accesseds
ssh client
first-time enable
System view Optional
2 Specify the public key
of the server
ssh client
server-ip assign
rsa-key keyname
System view Required
3 Start the SSH client ssh2 System view Required
To Next Page
Loading...
Need help?
General