Procedure
1. Do a check on the transport sensors.
2. Remove the packaging material. To discard the packaging material, refer to
section 2.12.
3. Make sure that all parts are delivered according to the order. Refer to the order
and section 10.3.
4. If you find damage or the parts are not according to the order, contact the local
representative of the manufacturer.
4.2.2 Do a check of the transport sensors
Preliminary requirements
• Installation engineer
Procedure
1. Do a check on the sensors (A) that
record the shocks during transport.
2. Do a check on the sensors (B)
that record the maximum tilt during
transport.
3. If the sensors (A) show a red
indication or the sensors (B) show a
tilt that is too high, do these steps:
For the transport specifications, refer
to section 10.4.
a. Refuse the delivery of the EVSE.
b. Make a note on the delivery
receipt.
c. Within three days of the delivery,
ask the transport company for an inspection.
d. If you see damage on the cabinet, through the packaging material, do not
unpack the EVSE.
e. Contact the manufacturer and give details of the delivery problems.
TiltWatch PLUS
TiltWatch PLUS
ShockDot
WARNING
ShockDot
WARNING
A
B
Transport, handling and unpacking
56 9AKK108467A6398-EN | 002
To Next Page
Loading...
Need help?
General
