7 Maintenance and cleaning
7.1 Maintenance schedule for the owner
Task Frequency Procedure
Clean the cabinet. 4 months Refer to section 7.2.
Do a check for damage on
the EV charge cables and
the connectors.
3 months Refer to section 7.3.
Do a check for damage on
the cabinet.
6 months Refer to section 7.3.
Replace the air inlet filters. 1 year Refer to section 7.3.
Make sure that the manu-
facturer does maintenance
on the EVSE.
1 year Ask the manufacturer to
do the task. Refer to sec-
tion 1.11.
Replace the air outlet fil-
ters.
After the first year, then 2
years
Refer to section 7.4.
Replace the heater. 5 years Contact the manufacturer.
Refer to section 1.11.
7.2 Clean the cabinet
Preliminary requirements
• Owner
• Cleaning agent. Refer to
section 10.22.
• Non-abrasive tool. Refer to
section 10.22.
Danger:
Hazardous voltage
• Do not apply high-pressure water jets. Water can leak into the
cabinet.
Note: When the EVSE is put in a corrosion sensitive environment,
superficial rust is possible on welding points. This rust is only visual.
There is no risk for the integrity of the cabinet. The procedure below
removes the rust.
Procedure
1. Rinse with low-pressure tap water to remove rough dirt.
2. Apply a a solution of cleaning agent to the cabinet and let it soak.
3. Manually remove dirt. Use the non-abrasive tool.
Caution:
Do not use abrasive tools.
4. Rinse with low-pressure tap water.
5. If necessary, apply wax on the front for extra protection and gloss.
6. If there was rust and you want it not to appear again, apply a rust-preventive
primer. Ask the manufacturer for specifications and instructions.
Maintenance and cleaning
84 9AKK108467A6398-EN | 002
To Next Page
Loading...
Need help?
General
