APRILIA SHIVER 900 User Manual

•
Remove the bushings with the crank-
case cold, using a press and the spe-
cific tool and pushing inward from the
outside of the crankcase.
Specific tooling
020726Y Bushing extractor
Installing
•
The orientation of the semi-bushings
must match the specifications indica-
ted in the drawing as closely as possi-
ble.
NOTE
WHEN REPLACING THE SEMI-BUSHINGS ALONE, THE
NEW COMPONENTS MUST BE THE SAME COLOUR AS
THE REMOVED COMPONENTS. IF THE COLOUR OF THE
OLD COMPONENTS IS NO LONGER VISIBLE, USE THE
TABLE TO IDENTIFY THE CORRECT COMPONENTS, RE-
FERRING TO THE CRANKCASE AND CRANKSHAFT
CLASSES.
Key:
* Semi-bushing joint line.
•
Fit the new bushings with the crank-
case cold, using a press and the spe-
cific tool and pushing outward from the
inside of the crankcase, until the punch
comes into contact with the crankcase
surface.
Specific tooling
020727Y Bushing punch
Assembling the connecting rod
CAUTION
TO FIT THE CONNECTING RODS, CHECK THE COUPLING TYPES INDICATED IN THE "CRANK-
CASE- CRANKSHAFT CONNECTING ROD" SECTION, IN THE "CHARACTERISTICS" CHAPTER
OF THE WORKSHOP MANUAL.
SHIVER 900 Engine
ENG - 273

APRILIA SHIVER 900 Specifications

General

Displacement	896.1 cc
Transmission	6-speed
Rear Brakes	240 mm disc, single-piston caliper
Engine Type	V-Twin, 4-stroke
Power	70 kW (95.2 hp) @ 8, 750 rpm
Torque	90 Nm at 6, 500 rpm
Fuel System	Electronic fuel injection
Front Suspension	Inverted fork with adjustable preload and rebound damping
Rear Suspension	Aluminum swingarm with adjustable rebound and preload
Front Brakes	Dual 320 mm discs, radial 4-piston calipers
ABS	Standard
Traction Control	Adjustable traction control
Ride Modes	Sport, Touring, Rain
Seat Height	810 mm
Wheelbase	1, 460 mm
Fuel Capacity	15 liters
Dry Weight	199 kg (439 lbs)