Opening and closing
●
Aft
er a time.
●
OR:
if the vehicle is unlocked with the but-
ton on the key.
●
OR: if the boot is opened.
●
OR: if the vehicle is unlocked manually with
the key.
Keyless Access temporary disconnection
function*
You can deactivate the vehicle's Keyless
Access unlocking for one locking and un-
locking cycle.
●
Move the gear lever to position P since
otherwise the vehicle cannot be locked.
●
Close the door.
●
Push the central locking button on the
remote control and touch the locking sensor
surface of the driver door handle
›››
Fig. 77
B
within the following 5 seconds.
Do not gr
asp the door handle; otherwise the
v
ehicle will not unlock. Deactivation is also
possible if the vehicle is locked through the
driver’s door lock.
●
To check that the function has been deac-
tivated, wait at least 10 seconds, grip and pull
on the door handle. The door should not
open.
The next time the door can only be unlocked
via the remote control or the lock cylinder.
The next time the door is locked/unlocked,
Keyless Access will be active again.
Keyless Access permanent disconnection
function*
You can deactivate the vehicle unlock with
Keyless Access permanently in the infotain-
ment system so that others cannot unlock or
start the vehicle.
Convenience functions
To close all the electric windows and the
sunroof using the comfort function, keep a
finger for a few seconds on the locking sen-
sor surface
›››
Fig. 77
B
(arrow) of the door
handle until the windo
w
s and roof have
closed.
How the doors open when touching the
sensor surface on the door handle will de-
pend on the settings that have been activa-
ted in the infotainment system, using the
function button > Exterior > Closing.
CAUTION
The sensor surfaces on the door handles
could engage if hit with a water jet or high
pressure steam if there is a valid vehicle key
in the proximity. If at least one of the elec-
tric windows is open and the sensor surface
›››
Fig. 77
B
(arrow) on one of the handles is
activat
ed continuously, all windows will
close.
Note
●
If the vehicle battery has little or no
charge, or the vehicle key battery is almost
or entirely out of charge, you will probably
not be able to lock or unlock the vehicle
with the Keyless Access system. The vehicle
can be unlocked or locked manually
›››
page 103.
●
To control the proper locking of the vehi-
cle, the release function is disabled for ap-
prox. 2 seconds.
●
If the message Keyless system faulty
is displayed on the screen of the dash pan-
el, abnormalities may occur in the opera-
tion of the Keyless Access system. Contact
a specialised workshop. To do so, CUPRA
recommends going to a specialised CUPRA
dealer or any SEAT dealership.
●
Depending on the function set on the in-
fotainment system for the mirrors, the ex-
terior mirrors will unfold and the surround
lighting will come on when unlocking the
vehicle using the sensor surface on the
driver and passenger door handles
›››
page 124.
●
If there is no valid key inside the vehicle
or the system fails to detect one, a warning
will display on the dash panel screen. This
could happen if any other radio frequency
signal interferes with the key signal (e.g.
from a mobile device accessory) or if the
key is covered by another object (e.g. an
aluminium case).
»
99
To Next Page
Loading...
Need help?
General
