EasyManuals Logo

Cupra FORMENTOR User Manual

Cupra FORMENTOR
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #221 background imageLoading...
Page #221 background image
Start and driving
Tiptronic gives the driver the option to
chang
e g
ears manually.
When you change to the Tiptronic pro-
gramme, the vehicle remains in the currently
selected gear. This is possible as long as the
system is not changing gear automatically
due to a traffic situation.
Using Tiptronic with the steering wheel
paddles
The gear shift paddles can be used when the
selector lever is in the position D/S.
Press the gearshift paddle
+
to select a
higher g
e
ar
Fig. 143 .
Press the gearshift paddle
to select a
lo
w
er gear.
To exit the Tiptronic mode, pull the right-
hand gear shirt paddle towards the steering
wheel for approximately 1 second.
To keep Tiptronic mode permanently switch-
ed on, move the selector lever to the S posi-
tion. If the selector lever is in position D and
the gear shift paddles are not operated for
some time, the Tiptronic mode will automat-
ically be switched off.
CAUTION
When accelerating, if a higher gear is not
selected, it will automatically change short-
ly before reaching the maximum permitted
RPM.
Also, if a low
er gear is selected, the sys-
tem will not change until it detects that the
engine will not reach its maximum RPM.
Driving with an automatic gearbox
The gearbox changes gear ratios automati-
cally as the vehicle mo
ves.
The engine can only be started with the lever
in the N position and the P button must be lit
up (the parking lock remains active).
Driving down hills
Under certain circumstances it may be ad-
vantageous to use the Tiptronic mode to se-
lect the gear manually according to driving
conditions
.
St
op/P
ark
To park on flat ground, just press the P but-
ton
Fig. 142 . On slopes the parking brake
should first be applied and then press the P
button.
If the driver door is opened and the P button
has not been activated, the vehicle could
move. The following warning is displayed on
the instrument panel: Gear change:
selector lever in the drive posi-
tion!. Additionally, a buzzer will sound.
Stopping on a downhill
Always apply the brake pedal firmly to pre-
vent the vehicle from moving; if necessary,
apply the electronic parking brake
.
Do not acceler
at
e while a range of gears is
engaged to prevent the car from rolling
downhill
.
St
arting off uphill with the Aut
o Hold func-
tion
Once you have engaged a gear, take your
foot off the brake pedal and gently press the
accelerator.
Starting off uphill without the Auto Hold
function
Pull on the electronic parking brake but-
ton.
Once you have engaged a gear, gently
press the accelerator and pull on the elec-
tronic parking brake button.
Back-up programme
If all the positions of the lever are shown over
a light background on the instrument panel
display, there is a system fault and the auto-
matic gearbox will operate in with the back-
up programme. It is still possible to drive the
vehicle, however, at low speeds and within a
selected range of gears. Driving in reverse
gear may not be possible.
»
219

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cupra FORMENTOR and is the answer not in the manual?

Cupra FORMENTOR Specifications

General IconGeneral
BrandCupra
ModelFORMENTOR
CategoryAutomobile
LanguageEnglish

Related product manuals