EasyManuals Logo

Cupra FORMENTOR User Manual

Cupra FORMENTOR
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
Control instruments and warning lamps
In some situations, the s
ystem may incor-
rectly interpret an intended driving ma-
noeuvre as driver tiredness.
No warning is given in the event of the ef-
fect called microsleep!
Please observe the indications on the in-
strument panel and act as is necessary.
Note
Fatigue detection has been developed for
driving on motorways and well paved roads
only.
If there is a fault in the system, have it
checked by a specialised workshop.
Road signs detection system*
1)
Fig. 54
On the instrument panel display: exam-
ples of recognised signals.
The traffic signal detection system is activa-
t
ed whene
ver the vehicle ignition is switched
on.
The system records the standard traffic signs
in front of the vehicle with a camera located
on the base of the interior mirror and pro-
vides information about speed limits, hazard
warnings and overtaking prohibitions.
Within its limitations, the system also displays
additional signals, such as time-specific pro-
hibitions, signs for vehicles towing trailers
page 288 or limitations that only apply in
the event of rain. Even on journeys without
signs, the system may display any applicable
speed limits.
The traffic sign detection system does not
work in all countries. Keep this in mind when
travelling abroad.
Shown on the display
In Germany, on motorways and vehicle
roads, besides speed limits and overtaking
provisions the system also displays the end of
prohibition signs. The valid speed limit at the
time in other countries is always shown.
The traffic signs detected by the system are
displayed on the dash panel display
Fig. 54 and, depending on the navigation
system fitted in the vehicle, on the infotain-
ment system as well
page 85 .
Hazard warning signs are not displayed in the
infotainment system.
Road sign detection system messages:
There are no traffic signs available
The system is in its start-up phase.
OR: the camera has not recognized any
mandatory or prohibitive sign.
Error: Dynamic Road Sign Display
There is a fault in the system. Have the sys-
tem checked by a specialised workshop.
Speed warning currently unavailable
The speed warning function of the road
sign detection system is faulty. Have the sys-
tem checked by a specialised workshop.
Dynamic Road Sign Display: please
clean the windscreen.
The windscreen is dirty in the camera area.
Clean the windscreen.
Dynamic Road Sign Display currently
restricted.
The navigation system is not transmitting
data. Check if the navigation system has up-
dated maps.
»
1)
System available depending on the country.
73

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cupra FORMENTOR and is the answer not in the manual?

Cupra FORMENTOR Specifications

General IconGeneral
BrandCupra
ModelFORMENTOR
CategoryAutomobile
LanguageEnglish

Related product manuals