EasyManuals Logo

Cupra FORMENTOR User Manual

Cupra FORMENTOR
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #290 background imageLoading...
Page #290 background image
Driving
Parking
In the infotainment system select > As-
sist
ants > P
arking aid before passing in front
of the selected parking space.
With reverse assist connected and in work-
ing order, press the function button .
Place the vehicle in front of the parking
space
Fig. 183
2
.
Reverse while turning the steering wheel so
that the y
ello
w lines enter the parking space.
The green and yellow lines must match the
side boundary lines
3
.
Stop the vehicle when the red line has
r
e
ached the rear boundary
4
.
Problems and solutions
The system behaves differently than ex-
pect
ed
Ther
e can be several causes:
The camera is dirty
page 351 . In addi-
tion to dirt and snow, camera visibility can be
reduced by detergent residue or any type of
coating.
The system requirements must be met
page 287.
The camera is covered with water.
The factory-fitted towing bracket must not
be electrically connected to a trailer
page 295.
The vehicle has some type of damage in
the camera area, e.g. due to a parking im-
pact.
The field of view of the camera is blocked
by an accessory, e.g. a bicycle carrier system.
Changes have been made to the paint in
the camera area, or structural modifications
have been made to a component such as
the running gear.
Camera with no visibility, fault message,
the system disconnects
Clean the camera or remove possible ad-
hesives or accessories from it
page 351 .
Check for visible damage.
Possible solution
Temporarily disconnect the system.
Check if one of the causes indicated above
has occurred.
Once the source of the problem has been
eliminated, the system may be reconnected.
If the system still behaves unpredictably,
have it checked by a specialised workshop.
Towing bracket device*
Trailer mode
Introduction
Take into account country-specific regula-
tions about driving with a trailer and the use
of a t
owing bracket.
The vehicle has been developed primarily for
carrying people, although it can also be used
to tow a trailer if fitted with the correspond-
ing technical equipment. This additional load
has an effect on the useful life, fuel con-
sumption and vehicle performance and in
some cases can reduce the service intervals.
Driving with a trailer requires more force
from the vehicle, and thus more concentra-
tion from the driver.
In winter, winter tyres should be fitted on
both the vehicle and the trailer.
Maximum vertical load technically permit-
ted on the coupling device
The maximum vertical load technically per-
mitted from the trailer draw bar on the tow-
ing bracket's tow ball is 80 kg.
Vehicles with the Start-Stop system
If the vehicle has a factory-fitted towing
bracket or one that is retrofitted by CUPRA,
288

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cupra FORMENTOR and is the answer not in the manual?

Cupra FORMENTOR Specifications

General IconGeneral
BrandCupra
ModelFORMENTOR
CategoryAutomobile
LanguageEnglish

Related product manuals