Cupra FORMENTOR User Manual

Operation
●
The he
ating must be activ
ated every time
you want to set off. Similarly, the departure
time must reactivate each time.
●
The control lamp  (fuel level indicator)
lights up.
Note
●
Noises will be heard while the auxiliary
heater is running.
●
When the air humidity is high and the in-
side temperature low, condensation from
the heating and ventilating system may
evaporate when the auxiliary heater is
switched on. In this case, steam may be re-
leased from underneath the vehicle. This
does not mean that there is a vehicle mal-
function.
●
If the vehicle is tilted, e.g. if parked on a
slope, the operation of the auxiliary heater
may be restricted if the fuel tank level is low
(just above the reserve level).
●
If the auxiliary heater is used a number of
times for a long period of time, the 12-volt
battery will lose its charge. To recharge the
battery, the vehicle must be driven for a
number of kilometres from time to time. As
a guideline: the journey should last approx-
imately as long as the heater was connec-
ted.
●
At temperatures below +5 °C (+41 °F), the
auxiliary heater may switch itself on auto-
matically when the engine is switched on.
The auxiliary heater is switched off again
after a certain time.
Stationary air conditioning*
Introduction
3 Valid for: hybrid vehicles.
With st
ationary air conditioning, the vehicle
interior can be cooled, ventilated or heated
while the vehicle is parked. It can also be
used to demist and remove ice or a thin layer
of snow from the windscreen. The stationary
air conditioning is powered by the vehicle’s
electrical socket or high-voltage battery.
Stationary air conditioning can be program-
med and controlled in the Infotainment sys-
tem in the Battery Manager menu, through
the CUPRA CONNECT mobile App and on
the MyCUPRA website.
CAUTION
Food, medicines and other objects sensi-
tive to heat and cold may be damaged or
spoiled by the air coming out of the vent.
●
Never place food, medicines or other
temperature-sensitive objects close to the
air vents.
Note
Operating the stationary air conditioning
while the charging cable is not connected
reduces the vehicle’s range. In the case of
extreme outside temperatures, the station-
ary air conditioning may not have sufficient
heating or cooling capacity to reach the
desired set t
emperature.
Operating the stationary air condi-
tioning
3 Valid for: hybrid vehicles.
Oper
ation of the stationary air condition-
ing when the charging connector is not
plugged in
The stationary air conditioning can operate
when the charging connector is not plugged
in When the charging connector is not plug-
ged in, the stationary air conditioning oper-
ates with the high-voltage battery.
●
Open the Battery Manag
er menu.
●
Select the settings menu.
●
Turn on the Enable High-Voltage Battery
Power function if necessary.
The stationary air conditioning only works if
the high voltage battery is sufficiently charg-
ed.
Setting the desired temperature
●
The desired temperature for the stationary
air conditioning is selected in the Battery
Manager Infotainment system menu using 
or .
158

Cupra FORMENTOR Specifications

General

Brand	Cupra
Model	FORMENTOR
Category	Automobile
Language	English