EasyManuals Logo

Cupra FORMENTOR User Manual

Cupra FORMENTOR
388 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
Emergencies
and request assistance from an authorised
t
echnician.
Disconnect the air compr
essor. Unscrew
the tyre inflator tube from the tyre valve.
When the tyre pressure is between 2.5 and
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
Attach the sticker
Fig. 34
2
to the in-
strument clust
er, within the driv
er's visual
field.
Check the pressure again after 10 minutes
page 46.
WARNING
When inflating the wheel, the air compres-
sor and the inflator tube may become hot.
Protect hands and skin from hot parts.
Do not place the hot flexible inflator tube
or hot air compressor on flammable mate-
rial.
Allow them to cool before storing the de-
vice.
If it is not possible to inflate the tyre to at
least 2.0 bars (29 psi / 200 kPa), the tyre is
too badly damaged. The sealant is not in a
good condition to seal the tyre. Do not con-
tinue driving. Seek specialist assistance.
CAUTION
Switch off the air compressor after a maxi-
mum of 8 operational minutes to avoid
overheating! Before switching on the air
compressor ag
ain, let it cool for several mi-
nutes.
Check after 10 minutes of driving
Screw the inflator tube
Fig. 34
5
again
and check the pressur
e on the gauge
6
.
1.3 bar (19 psi / 130 kP
a) and lower:
Stop the vehicle! The tyr
e cannot be
sealed sufficiently with the tyre mobility set.
You should obtain professional assistance
.
1.4 bar (20 p
si / 140 kP
a) and higher:
Set the tyre pressure to the correct value
again.
Carefully resume your journey until you
reach the nearest specialised workshop
without exceeding 80 km/h (50 mph).
Have the damaged tyre replaced.
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious injury.
Do not continue driving if the tyre pres-
sure is 1.3 bar (19 psi / 130 kPa) and lower.
Seek specialist assistance.
Changing a wheel
Preliminary actions
Stop the vehicle on a level surface and in a
safe place, as f
ar away from road traffic as
possible.
Apply the electronic parking brake.
Switch on the hazard warning lights.
Manual transmission: engage 1st gear.
Automatic transmission: swit
ch on the
parking lock by pressing button P.
If towing a trailer, unhitch the trailer from
your vehicle.
Have the vehicle tool kit
page 43 and
the spare wheel* ready
page 343 .
Follow the legal provisions of each country
(reflective vest, warning triangles, etc.).
Get all occupants out of the vehicle and
keep them out of the danger zone (e.g. be-
hind the guard rail).
WARNING
Always observe the above steps and pro-
tect yourself and other road users.
If you change the wheel on a slope, block
the wheel on the opposite side of the car
with a stone or similar to prevent the vehi-
cle from moving.
46

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cupra FORMENTOR and is the answer not in the manual?

Cupra FORMENTOR Specifications

General IconGeneral
BrandCupra
ModelFORMENTOR
CategoryAutomobile
LanguageEnglish

Related product manuals