Cupra FORMENTOR User Manual

Opening and closing
Resetting and memorising the opening
angle
F
or the r
ear lid to reopen completely, the
opening angle must be reset and memorised
again.
●
Release the rear lid and open it to the
memorised height.
●
Lift the rear lid by hand as far as it goes. To
do this, some force will have to be used.
●
Press the  button
›››
Fig. 82 on the rear
lid for at least 3 seconds.
●
This resets and memorises the factory-set
opening angle. Memorisation is indicated by
blinking of the hazard warning lights and an
audible warning.
Automatic protection against overheating
If the system is operated repeatedly in a
short space of time, it automatically switches
off to prevent overheating.
Once the system is cool again, the function
can be reused. Until then, the rear lid can
only be opened and closed by hand using
reasonable force.
If with the rear lid open the vehicle battery is
disconnected
›››
page 329 or the corre-
sponding fuse burns out
›››
page 58 , the sys-
tem will have to be reset. This requires clos-
ing the rear lid completely once.
Emergency unlocking
›››
page 108
WARNING
If a lot of snow builds up on the rear lid or it
is heavily loaded, the rear lid may not open
or, after opening, it may lower by itself due
to the extra weight and cause serious in-
jury.
●
Do not open the rear lid when there is a
lot of snow on it or when carrying a load
(e.g. on a rack).
●
Before opening the rear lid, remove the
snow or the load.
Rear lid with sensor-controlled open-
ing and closing (Easy Open)
Fig. 84
Rear lid with sensor-controlled opening
(Easy Open).
If there is a valid vehicle key in the proximity
of the r
e
ar lid, it is possible to unlock and
open or close it moving one foot in the area
of the sensors located under the rear bump-
er.
●
Switch the ignition off.
●
Stand in front of the rear bumper, in the
middle.
●
With a brisk movement, bring your foot
and lower leg as close as you can to the
bumper. The lower part of the leg needs to
be close to the upper sensor area and your
foot must be close to the lower sensor area
›››
Fig. 84
1
.
●
Quickly remove your foot and lower leg
fr
om the sensor ar
eas
›››
Fig. 84
2
. The rear
lid will open aut
omatically.
●
If the r
ear lid fails to open, repeat the pro-
cedure after a few seconds.
The rear lid can be closed with another foot
movement similar to the opening one (provi-
ded a valid vehicle key is in the proximity of
the rear lid).
When closed, the rear lid automatically locks
if the vehicle has been locked beforehand
and there is no valid key inside.
While the rear lid is in motion (either open-
ing or closing), it can be stopped with anoth-
er foot movement similar to the opening one
(provided a valid vehicle key is in the proximi-
ty of the rear lid).
»
107

Cupra FORMENTOR Specifications

General

Brand	Cupra
Model	FORMENTOR
Category	Automobile
Language	English