Airbag system
Activate and deactivate front passen-
ger front airbag*
Fig. 15
Switch for activating and deactivating the
front passenger airbag.
Fig. 16
On the roof console: control lamp for the
deactivation of the front passenger front airbag.
Deactivate the front passenger front airbag
only if y
ou ha
ve to use a rear-facing child
seat in the front passenger seat.
CUPRA recommends fitting the child seat in
the rear seat to avoid having to deactivate
the front passenger airbag.
When the front passenger airbag is deacti-
vated, this means that only the front passen-
ger front airbag is deactivated. All the other
airbags in the vehicle remain activated.
Deactivate and activate the front passen-
ger front airbag
●
Switch the ignition off.
●
Open the door on the front passenger
side.
●
Insert the key into the slot of the switch for
deactivating the front passenger airbag
›››
Fig. 15. About 3/4 of the key should enter;
this is as far as it will go.
●
Turn the key gently to change its position
to (deactivate) or to (activate). If you
have difficulty, ensure that you have inserted
the key as far as it will go.
●
Close the front passenger door.
●
When deactivating the airbag, switch the
ignition on and check that the control lamp
remains lit where it says
in the roof console
›››
Fig. 16 .
●
When reactivating the airbag, check that
when the ignition is switched on, the
control lamp does not light up and the
lamp lights up for 60 seconds and then turns
off.
WARNING
●
The driver of the vehicle is responsible
for disabling or switching on the airbag.
●
Always switch off the ignition before disa-
bling the front passenger airbag! Failure to
do so could result in a fault in the airbag de-
activation system.
●
Never leave the key in the airbag disa-
bling switch as it could get damaged or en-
able or disable the airbag during driving.
●
If for any reason an airbag is deactivated,
reactivate it as soon as possible so that it
can fulfil its protective function.
27
To Next Page
Loading...
Need help?
General
