Cupra FORMENTOR User Manual

Infotainment system
General instructions for use
Operating indications
●
The infotainment needs a few seconds for
the complete st
art-up of the system and
during that time it does not react to inputs.
Only the image of the rear view camera* sys-
tem can be displayed during system start-up.
●
The display of all indications and the exe-
cution of functions only takes place once the
infotainment system has finished booting.
The duration of the system booting depends
on the number of infotainment functions
and may take longer than normal in the
event of very high or very low temperatures.
●
When using the infotainment system and
corresponding accessories, e.g., he
ad-
phones, bear in mind country-specific regu-
lations and legal provisions.
●
Some functions of the infotainment system
require an active CUPRA CONNECT user ac-
count and an Internet connection for the ve-
hicle. The data transmission must not be
limited to perform the functions.
●
To use the infotainment system, simply
lightly press a button or touch the screen.
●
For the correct operation of the infotain-
ment system it is important that it is switched
on and that, if necessary, the time and date
of the vehicle are set correctly.
●
If a function button is missing on the
screen, it is not a device defect, but corre-
sponds to the specific equipment of the
country or version.
●
Some infotainment functions can only be
selected when the vehicle is at a standstill. In
some countries the parking lock must also
be enabled (button P ) or the selector con-
trol must be in the neutral position N. This is
not a malfunction, but is due to compliance
with legislation.
●
Restrictions on the use of devices using
Bluetooth® technology may apply in some
countries. For further information, contact
the local authorities.
●
If you disconnect the 12-volt battery, turn
on the ignition before restarting the infotain-
ment system.
●
If the setup is changed, this may change
the display on the screen and in some cases,
the infotainment system may behave in a
manner different to that described in this in-
struction manual.
●
Ensure that any repairs or modifications
that need to be carried out on the infotain-
ment system are carried out by a specialised
workshop. To do so, CUPRA recommends
going to a specialised CUPRA dealer or any
SEAT dealership.
●
Using a mobile phone device inside the ve-
hicle may cause noise in the speakers.
●
In some countries, the infotainment sys-
tem automatically shuts off when the engine
is switched off and the vehicle's 12-volt bat-
tery charge level is low.
●
On vehicles with park assist, the audio
source volume is automatically lowered
when reverse gear is selected. The volume
reduction can be adjusted.
●
Information about the included software
and the license conditions can be found in
Settings > Copyright.
●
When selling or lending the vehicle, make
sure that all saved data, files and settings
have been deleted and, if necessary, exter-
nal audio sources and data media have been
removed.
Note
You will find more information and tips for
using the infotainment system in the Help
menu.
HOME screen
In the control and display unit you can set up
the vie
w
s and representation on the home
screen or use the factory setting templates.
If an icon is missing on the screen, it is not a
device defect, but corresponds to the spe-
cific equipment of the country or version.
166

Cupra FORMENTOR Specifications

General

Brand	Cupra
Model	FORMENTOR
Category	Automobile
Language	English