Cupra FORMENTOR User Manual

Start and driving
CUPRA therefore recommends using
the char
ging sock
et to charge the high-
voltage battery, whenever possible
›››
page 303 .
The high-voltage battery charge level is
kept at around the current level while
driving. If you accelerate harder or in-
crease the vehicle speed, the combus-
tion engine starts up. When permitted
by the driver’s demand for acceleration
and the vehicle speed, the vehicle
switches back to electric mode.
Pressing this symbol selects a lower the-
oretical charge level. The vehicle only
uses the battery's charge when it is
above the selected theoretical charge
level. The rest is kept until the end of
the journey.
The Intelligent Hybrid App allows the user
to save electrical energy until reaching home
(charging point) with just “one click”. If this
option is not selected, the maximum amount
of electrical energy will be consumed until
the selected destination is reached. If the
user has no active route, the function will of-
fer the activation of a predictive route and
BMA mode from the widget itself with just
one click.
=

Show the active operating mode
The operating mode active at any given time
is displayed on the instrument cluster dis-
play, e.g. .
WARNING
Switching to a different operating mode
while driving can distract you from traffic
conditions and cause accidents.
Note
Information about the operating mode that
is currently active is displayed on the in-
strument cluster display, along with the
charge level of the high-voltage battery.
Troubleshooting

The E-MODE operating mode is not
a
vailable
The indicator lamp lights up in white.
The E-MODE operating mode

(driving in
electric mode) cannot be used temporarily
because one or more conditions are not
met.
●
The conditions must be met to use the E-
MODE operating mode
›
››
page 212 .
Start-Stop system
Control lamps

It lights up
The Start-Stop system is available, the automatic en-
gine shutdown is active.

It lights up
The Start-Stop system is not available or has been dis-
connected.
Indications for the driver on the instru-
ment clust
er scr
een
Start-Stop system deactivated. Start
the engine manually
●
This indication for the driver shows that
the Start-Stop system cannot start the en-
gine again.
Start-Stop system: Fault! Function
not available
●
There is a fault in the Start-Stop system.
Take the vehicle to a workshop to have the
fault repaired.
Description and operation
The Start-Stop system helps you to save fuel
and r
educe C
O
2
emissions.
»
213

Cupra FORMENTOR Specifications

General

Brand	Cupra
Model	FORMENTOR
Category	Automobile
Language	English