Information for the user
●
Plastic parts and elast
omer
s are marked in
accordance with ISO 1043, ISO 11469 and
ISO 1629.
Choice of materials
●
Use of recycled materials.
●
Use of compatible plastics in the same part
if its components are not easily separated.
●
Use of recycled materials and/or materials
originating from renewable sources.
●
Reduction of volatile components, includ-
ing odour, in plastic materials.
●
Use of CFC-free coolants.
Ban on heavy metals, with the exceptions
dictated by law (Annex II of ELV Directive
2000/53/EC): cadmium, lead, mercury,
hexavalent chromium.
Manufacturing methods
●
Reduction of the quantity of thinner in the
protective wax for cavities.
●
Use of plastic film as protection during ve-
hicle transport.
●
Use of solvent-free stickers.
●
Use of CFC-free coolants in cooling sys-
tems.
●
Recycling and energy recovery from resi-
dues (RDF).
●
Improvement in the quality of waste water.
●
Use of systems for the recovery of residual
heat (thermal recovery, enthalpy wheels,
etc.).
●
The use of water-soluble paints.
Recycling of electrical or electronic
devices
All electrical or electronic devices (EED) that
are not permanently fitt
ed in the vehicle
must be marked with the following symbol:
This symbol indicates that EED must not be
discarded as home waste but through selec-
tive waste collection.
Information about the EU Di-
rective 2014/53/EU
Simplified EU compliance declaration
Your vehicle has different radioelectrical de-
vices. The manuf
act
urers of these devices
declare that they comply with Directive
2014/53/EU when legally required.
The full text of the EU compliance declara-
tion is available online at the following ad-
dress:
www.cupraofficial.com
Addresses of the manufacturers
According to the Directive 2014/53/EU, all
rele
vant components must include the ad-
dress of the manufacturer.
The address of the manufacturers of com-
ponents that, due to their size or nature,
cannot include a sticker are listed below, as
long as it is legally required:
358