D-Link DSR-Series User Manual 273
Section 11 - Troubleshooting
Restoring factory-default conguration settings
To restore factory-default conguration settings, do either of the following:
1. Do you know the account password and IP address?
• If yes, select Maintenance > Firmware & Cong > Soft Reboot and click Default.
• If no, do the following:
On the rear panel of the router, press and hold the Reset button about 10 seconds, until
the test LED lights and then blinks. Release the button and wait for the router to reboot.
2. If the router does not restart automatically; manually restart it to make the default settings eective.
3. After a restore to factory defaults —whether initiated from the conguration interface or the Reset
button — the following settings apply:
• LAN IP address: 192.168.10.1
• Username: admin
• Password: admin
• DHCP server on LAN: Enabled
• WAN port conguration: Get conguration via DHCP