D-Link DSR-Series User Manual 48
Section 5 - Connect to the Internet
Field Description
WAN Mode Select Load Balancing from the drop-down menu.
Load Balance Select Spillover Mode.
WAN Health Check
• DNS lookup using WAN DNS Servers: DNS Lookup of the DNS Servers of the primary link is used to
detect primary WAN connectivity.
• DNS lookup using DNS Servers: DNS Lookup of the custom DNS Servers can be specied to check the
connectivity of the primary link.
• Ping these IP addresses: These IP’s will be pinged at regular intervals to check the connectivity of the
primary link.
Retry Interval is Enter the time in seconds to initiate the WAN health check. Default is every 30 seconds.
Failover After Enter the number of failures before the router will enable the failover process.
Load Tolerance Enter the percentage of bandwidth after which the router switches to the secondary WAN.
Max Bandwidth This sets the maximum bandwidth tolerable by the primary WAN for outbound trac.
Save Click to save and activate your settings.
Spillover
1. Click Network > Internet > WAN Mode.
2. Complete the elds from the table below and click Save.