Serial port Show serial status and statistics
Digi Connect EZ Mini User Guide
169
e. Log the time at which date was received or transmitted:
(config)>serial port1 logging hex true
(config)>
f. Log data as hexadecimal values:
(config)>serial port1 logging timestamp true
(config)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the RealPort service
After you have configured RealPort mode on the Connect EZ, you must enable and configure the
RealPort service. When this step is complete, all of the serial ports on the Connect EZ are configured
to use the RealPort service.
Web
1. Log into the Connect EZ WebUI as a user with Admin access.
2. On the menu, click System > Configuration > Device Configuration.
3. Expand Services.
4. Expand RealPort.
5. Click Enable to enable the RealPort service.
6. For RealPort Server Port, enter 1027. This is the default.
7. Enable Encryption to enable encryption of data. This is enabled by default.
8. (Optional) Configure authentication.
a. From the Authentication Method list box, select the Shared Secret - SHA256 option.
b. For Shared Secret, enter the authentication password to ensure secure communication.
Leave this field blank to disable authentication.
9. Enable Exclusive Mode to ensure that any connection from an IPaddress is closed when
opening a new connection from the same IPaddress. This disabled by default.
10. Enable RealPort Keepalive to send RealPort keepalive packets. This is enabled by default.
11. Enable TCP Port Keepalive to send TCPkeepalive packets. This is disabled by default.
12. Click Apply to save the configuration and apply the change.
Show serial status and statistics
To show the status and statistics for the serial port:
To Next Page
Loading...
Need help?
General