Central management Configure your device for Digi Remote Manager support
Digi Connect EZ Mini User Guide
666
16. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Collect device health data and set the sample interval
You can enable or disable the collection of device health data to upload to Digi Remote Manager, and
configure the interval between health sample uploads. By default, device health data upload is
enabled, and the health sample interval is set to 60 minutes. Each time a device connects to Digi
Remote Manager after the device boots (or re-boots), the device immediately uploads all health
metrics.
To avoid a situation where several devices are uploading health metrics information to Remote
Manager at the same time, the Connect EZ device includes a preconfigured randomization of two
minutes for uploading metrics. For example, if Health sample interval is set to five minutes, the
metrics will be uploaded to Remote Manager at a random time between five and seven minutes.
To disable the collection of device health data or enable it if it has been disabled, or to change the
health sample interval:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Monitoring > Device Health.
To Next Page
Loading...
Need help?
General