Services Configure a multicast route
Digi Connect EZ Mini User Guide
423
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a multicast route
Multicast routing allows a device to transmit data to a single multicast address, which is then
distributed to a group of devices that are configured to be members of that group.
To configure a multicast route:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Multicast.
4. For Add Multicast route, type a name for the route and click .
5. The new route is enabled by default. To disable, toggle off Enable.
6. Type the Source address for the route. This must be a multicast IP address between 224.0.0.1
and 239.255.255.255.
7. Select a Source interface where multicast packets will arrive.
8. To add one or more destination interface that the Connect EZ device will send mutlicast
packets to:
a. Click to expand Destination interfaces.
b. Click .
c. For Destination interface, select the interface.
d. Repeat for additional destination interfaces.
9. Click Apply to save the configuration and apply the change.
To Next Page
Loading...
Need help?
General