Services Use the iPerf service
Digi Connect EZ Mini User Guide
429
setup
(config)>
Repeat this step to include additional firewall zones.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Use the iPerf service
Your Connect EZ device includes an iPerf3 server that you can use to test the performance of your
network.
iPerf3 is a command-line tool that measures the maximum network throughput an interface can
handle. This is useful when diagnosing network speed issues.
The Connect EZ implementation of iPerf3 supports testing with both TCP and UDP.
Note Using iPerf clients that are at a version earlier than iPerf3 to connect to the Connect EZ device's
iPerf3 server may result in unpredictable results. As a result, Digi recommends using an iPerf client at
version 3 or newer to connect to the Connect EZ device's iPerf3 server.
Required configuration items
n Enable the iPerf server on the Connect EZ device.
n An iPerf3 client installed on a remote host. iPerf3 software can be downloaded at
https://iperf.fr/iperf-download.php.
Additional configuration Items
n The port that the Connect EZ device's iPerf server will use to listen for incoming connections.
n The access control list for the iPerf server.
When the iPerf server is enabled, the Connect EZ device will automatically configure its firewall
rules to allow incoming connections on the configured listening port. You can restrict access by
configuring the access control list for the iPerf server.
To enable the iPerf3 server:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
To Next Page
Loading...
Need help?
General