Virtual Private Networks (VPN) IPsec
Digi Connect EZ Mini User Guide
221
Debug an IPsec configuration
If you experience issues with an IPsec tunnel not being successfully negotiated with the remote end of
the tunnel, you can enable IPsec debug messages to be written to the system log. See View system
and event logs for more information about viewing the system log.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click VPN > IPsec.
4. Click to expand Advanced.
5. For Debug level, select one of the following:
n Disable debug messages.
n Basic auditing debug: Logs basic auditing information, (for example, SA up/SA down).
n Generic control flow : Select this for basic debugging information.
n Detailed control flow : More detailed debugging control flow.
n Raw data: Includes raw data dumps in hexadecimal format.
n Sensitive material: Also includes sensitive material in dumps (for example, encryption
keys).
6. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect EZ local command line as a user with full Admin access rights.
To Next Page
Loading...
Need help?
General