Digi Connect EZ Mini User Manual

Interfaces Wide Area Networks (WANs)
Digi Connect EZ Mini User Guide
68
b. Set the test interval between connectivity tests:
(config)> network interface my_wan interval value(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
(config)> network interface my_wan surelink 600s
(config)>
The default is 15m.
c. If more than one test target is configured, set the success condition:
(config)> network interface my_wan success_condition value
(config)>
where value is either:
n one: Only one test needs to pass for Surelink to consider an interface to be up.
n all: All tests need to pass for SureLink to consider the interface to be up.
d. Set the number of times that the test must pass after failure, before the interface is
determined to be working and is reinstated.
(config)> network interface my_wan pass_threshold int
(config)>
The default is 1.
e. Set the amount of time that the device should wait for a response to a test attempt before
considering it to have failed:
(config)> network interface my_wan timeout value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set timeout to ten minutes, enter either 10m or 600s:
(config)> network interface my_wan surelink timeout 600s
(config)>
The default is 15s.
f. Set the amount of time to wait while the device is starting before SureLink testing begins.
This setting is bypassed when the interface is determined to be up.
(config)> network interface my_wan advanced delayed_start value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set delayed_start to ten minutes, enter either 10m or 600s:

Digi Connect EZ Mini Specifications

General

Brand	Digi
Model	Connect EZ Mini
Category	Server
Language	English