Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
139
16. See Configure SureLink active recovery to detect modem failures for information about
configuring active recovery.
17. Save the configuration and apply the change:
(config network interface my_wan)> save
Configuration saved.
>
18. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show WWAN status and statistics
Web
1. Log into the IX10 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network command at the Admin CLI prompt:
> show network
Interface Proto Status Address
---------------- ----- ------- -------------------------------
defaultip IPv4 up 192.168.210.1/24
defaultlinklocal IPv4 up 169.254.100.100/16
eth IPv4 up 192.168.2.1/24
eth IPv6 up fd00:2704::1/48
loopback IPv4 up 127.0.0.1/8
modem IPv4 up 10.200.1.101/30
modem IPv6 down
>
3. Additional information can be displayed by using the show network verbose command:
> show network verbose
Interface Proto Status Type Zone Device Metric
Weight
---------------- ----- ------- ------ -------- -------- ------ --
To Next Page
Loading...
Need help?
General
