Virtual Private Networks (VPN) NEMO
IX10 User Guide
466
Configure a NEMO tunnel
Configuring an NEMO tunnel with a remote device involves configuring the following items:
Required configuration items
n
Enable the NEMO tunnel.
The NEMO tunnel is enabled by default.
n
The IP address of the NEMO virtual network interface.
n
The firewall zone of the NEMO tunnel.
n
The IP address of the NEMO home agent server. This is provided by your cellular carrier.
n
The home agent's authentication key. This is provided by your cellular carrier.
n
Home agent registration lifetime. This is provided by your cellular carrier.
n
The local network interfaces that will be advertised on NEMO.
Additional configuration items
n
The home agent Software Parameter Index (SPI).
n
Path MTU discovery.
Path MTU discovery is enabled by default. If it is disabled, identify the MTU.
n
Care of address: the local network interface that is used to communicate with the peer.
l
If set to Interface, identify the local interface to be used. Generally, this will be the
Wirelesss WAN (Modem).
l
If set to IP address, enter the IP address.
n
The local network of the GREendpoint negotiated by NEMO.
l
If the local network is set to Interface, identify the local interface to be used.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
To Next Page
Loading...
Need help?
General
