Applications Develop Python applications
IX10 User Guide
609
Set up the IX10 for Python development
1. Access the IX10 local web interface
a. Use an Ethernet cable to connect the IX10 to your local laptop or PC.
The factory default IP address is 192.168.2.1
b. Log into the IX10 WebUI as a user with full admin access rights.
The default user name is admin and the default password is the unique password printed
on the label packaged with your device.
2. Go to the Configuration window
a. On the menu, click System.
b. Under Configuration, click Device Configuration. The Configuration window displays.
3. (Optional) If you want to connect to a local network (LAN) that has a DHCP server
a. Click Network > Interfaces > LAN > IPv4.
b. Select DHCP address.
For LAN configuration, see the following topics:
n
Change the default LAN subnet
n
Change the LAN address type
n
Allow remote access for web administration and SSH
4. Enable service discovery (mDNS)
a. Click Services > Service Discovery (mDNS).
b. Enable the mDNS service.
Note For more information, see Enable service discovery (mDNS).
5. Configure SSH access
a. Click Services > SSH.
b. Click Enable.
Note For more information, see the following topics: Configure SSHaccess, Use SSH with key
authentication, and Allow remote access for web administration and SSH.
6. Enable shell access
a. Click Authentication > Groups > admin.
b. Click the Interactive shell access option.
c. If this option is not displayed, see Disable shell access.
7. Click Apply to save the configuration and apply the changes.
The Apply button is located at the top of the WebUI page. You may need to scroll to the top of
the page to locate it.
Create and test a Python application
To develop a Python application for the IX10:
To Next Page
Loading...
Need help?
General
