Services Use the MQTTbroker service
IX10 User Guide
596
13. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
14. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show MQTTbroker information
You can view status and statistics about the MQTTbroker from either the WebUI or the command line.
Web
1. Log into the IX10 WebUI as a user with Admin access.
2. On the main menu, click Status.
3. Under Services, click MQTT Broker.
Command line
Show MQTT broker information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show mqtt command at the system prompt:
> show location
MQTT Broker Status
------------------
Enabled : true
Status : up
Version : mosquitto version 2.0.14
Uptime : (202s)
Totals
------
Bytes sent : 158400
Bytes received : 4500
Messages sent : 0
Messages received : 0
Clients
-------
Total : 1
To Next Page
Loading...
Need help?
General
