Digi IX10 User Manual

Serial port Configure RealPort mode using the Digi Navigator
IX10 User Guide
231
Navigator was installed can launch the Digi Navigator. This is the default.
7. Click Install. The Completing Digi Navigator Setup screen displays.
8. Choose the Run Digi Navigator option if you want to launch the Navigator when the
installation is complete.
9. Click Finishto complete the installation process.
Configure RealPort on a Digi device from the Digi Navigator
You can configure the IX10 to communicate with your computer using RealPort from the Digi
Navigator. You must enable RealPort on the device and then configure your computer for RealPort.
In this step, all serial ports on the device are set to RealPort mode and the RealPort service is enabled.
The COMports on your laptop are also configured.
Note You can also manually configure the device for RealPort by logging into the device's web UI. See
Advanced RealPort configuration without using the Digi Navigator.

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English