Routing IP routing
IX10 User Guide
261
(config network route policy 0)> dst mac MAC_address
(config network route policy 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example: Dual WAN policy-based routing
This example routes traffic to a specific IP address to go through the cellular WWAN interface, while all
other traffic uses the Ethernet WAN interface.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
To Next Page
Loading...
Need help?
General
