System administration Disable device encryption
IX10 User Guide
843
where value is either daily, weekly, or monthly. daily is the default.
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
7. (Optional) Configure automated checking for device firmware updates:
a. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates. To disable:
(config)> system schedule maintenance firmware_update_check device
false
(config)>
b. Set how often automated checking for device firmware should take place:
(config)> system schedule maintenance frequency value
(config)>
where value is either daily, weekly, or monthly. daily is the default.
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Disable device encryption
You can disable the cryptography on your IX10 device. This can be used to ship unused devices from
overseas without needing export licenses from the country from which the device is being shipped.
When device encryption is disabled, the following occurs:
n
The device is reset to the default configuration and rebooted.
n
After the reboot:
l
Access to the device via the WebUI and SSH are disabled.
l
All internet connectivity is disabled, including WANand WWAN. Connectivity to central
management software is also disabled.
l
All IP networks and addresses are disabled except for the default 192.168.210.1/24 network
on the local LAN Ethernet port. DHCP server is also disabled.
To Next Page
Loading...
Need help?
General
