Digi IX10 User Manual

Routing IP routing
IX10 User Guide
267
b. Set the label that will be used to identify this route policy:
(config network route policy 0)> label "Domain-based policy"
(config network route policy 0)>
c. Set the interface:
(config network route policy 0)> interface /network/interface/eth1
(config network route policy 0)>
d. Leave the source address type at the default of zone.
e. Leave the source address zone at the default of any.
f. Configure the destination address:
i. Set the destination to use a domain:
(config network route policy 0)> dst type domain
(config network route policy 0)>
ii. Add a domain and set it to youtube.com:
(config network route policy 0)> add dst domain end youtube.com
(config network route policy 0)>
You can add additional domains by repeating this step with a different domain name.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example: Route traffic to a specific WAN interface based on the
client MACaddress
This example routes all data from a certain client device through a cellular WAN based on the device's
MAC address, while all other client devices are routed through the Ethernet WAN.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.

Digi IX10 Specifications

General

Brand	Digi
Model	IX10
Category	Network Router
Language	English