Services Use the iPerf service
IX10 User Guide
597
Maximum : 5
Connected : 1
Disconnected : 0
Expired : 0
Subscriptions
-------------
Total : 1
Shared : 1
Message Store
-------------
Bytes : 151
Messages : 35
Retained messages : 40
PUBLISH Messages
----------------
Bytes sent : 0
Bytes received : 0
Messages sent : 0
Messages received : 0
Messages dropped : 0
>
3. Use the show mqtt command to return additional information, including averages over one,
five, and fifteen minutes.
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Use the iPerf service
Your IX10 device includes an iPerf3 server that you can use to test the performance of your network.
iPerf3 is a command-line tool that measures the maximum network throughput an interface can
handle. This is useful when diagnosing network speed issues, to determine, for example, whether a
cellular connection is providing expected throughput.
The IX10 implementation of iPerf3 supports testing with both TCP and UDP.
Note Using iPerf clients that are at a version earlier than iPerf3 to connect to the IX10 device's iPerf3
server may result in unpredictable results. As a result, Digi recommends using an iPerf client at
version 3 or newer to connect to the IX10 device's iPerf3 server.
Required configuration items
n
Enable the iPerf server on the IX10 device.
n
An iPerf3 client installed on a remote host. iPerf3 software can be downloaded at
https://iperf.fr/iperf-download.php.
To Next Page
Loading...
Need help?
General
