Fuji Xerox DocuCentre-V 3060 User Manual

Problem Solving
458
Problem Solving
15
Trouble during Faxing
This section describes how to resolve fax problems.
Note
z
For troubles during Internet faxing, refer to "E-mail Features Problems" (P.476).
z
The Fax features are not available for some models. An optional component is required. For more
information, contact our Customer Support Center.
Sending Problems
If you cannot send a fax, identify the symptom in the following table to perform the
remedy.
Symptom Cause Remedy
A Transmission
Report - Job
Undelivered is
output.
The fax was not sent
because of an error.
Check the Transmission Results in the
Transmission Report - Job Undelivered. If
an error code is displayed, refer to "Error
Code" (P.482).
Unable to
communicate
(general fax)
The phone line is not
connected correctly.
The machine is equipped with connectors
to which to connect phone
lines.Communication is enabled only
when the phone line is connected to the
correct connector.When the cable
connection is correct, the On-hook feature
allows you to call via general lines.
The phone dialing method
is not available.
Specify the same dialing method as the
one (Tone/10pps) subscribed for the
machine.
An error occurred with the
phone line.
Use a telephone near the machine to
check whether you can make a phone call.
If the phone call is disabled, the problem
is in the phone line, not in the machine.
The destination machine is
abnormal.
The data cannot be sent if the machine of
the recipient is turned off, is set to
"manual" receiving mode, or does not
support G3 reception.Call the recipient to
confirm the machine condition.
An incorrect fax number is
used.
Check the fax number and try sending
again.
The number is not for fax
number.
If no peep sound is heard from the
receiver when you call the number, the
number is not for a fax number.
You forgot the external
access number.
When calling from an extension line, the
external access number is required.
When dialing, dial the external access
number such as "0", and then dial the fax
number.
When the switchboard is changed and
you cannot send faxes, try the external
access number "0
*
" instead of "0".

Fuji Xerox DocuCentre-V 3060 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-V 3060
Category	All in One Printer
Language	English