Replacing Consumables
79
Maintenance
3
5
Close the finisher side cover.
z
If the cover is not completely closed, a message will appear and the machine remains paused.
Emptying Punch Waste Container (for Finisher-B1)
When the optional Finisher-B1 is installed and the hole punch waste container becomes full,
a message appears on the touch screen. When the message appears, empty the hole punch
waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container. Not
doing so will cause the container to fill up before the message telling you to empty the
container appears again, and this can cause machine malfunction.
z
Empty the hole punch waste container when the machine is on. If you empty the container while the
machine is off, the machine does not recognize that the container has been emptied.
z
When the
m
achine is i
n
the Power Sa
ver mode,
exit the Power Sa
ver mode by press
ing the <Power Saver>
button and the <Machine Status> button on the control panel before you replace the waste toner container.
z
When replacing the punch waste container, press the <Machine Status> button and check the current status
for the hole punch waste container even when the control panel is lit.
1
Make sure that the machine is not operating, lift the top transport cover, and then open the
front transport cover of the finisher.
2
Pull out the hole punch waste container.
To Next Page
Loading...
Need help?
General
