Fujitsu PRIMERGY RX2530 M6 User Manual

▶
Pull the HDD/SSD module completely out of its bay.
Installing a 2.5-inch dummy module
CAUTION
▶
If the removed HDD/SSD module is not replaced immediately,
always replace a dummy module into the unused HDD/SSD bay to
comply with applicable EMC regulations and satisfy cooling
requirements.
Figure 62: Installing the 2.5-inch dummy module
▶
Push the dummy module into the empty bay until it engages.
Concluding steps
▶
If applicable, "Installing the front cover with lock" on page
66.
7.5.4
Replacing a 2.5-inch HDD/SSD module
Customer Replaceable
Unit (CRU)
Hardware: 5 minutes
Tools: – Installation frame included: tool-less
– Installation frame excluded: Phillips PH1 / (+) No. 1 screw driver
Hard disk drive (HDD) / solid state disk (SSD)
144 Upgrade and Maintenance Manual RX2530 M6

Fujitsu PRIMERGY RX2530 M6 Specifications

General

Brand	Fujitsu
Model	PRIMERGY RX2530 M6
Category	Server
Language	English