Fujitsu PRIMERGY RX2530 M6 User Manual

▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 92.
▶
"Updating expansion card firmware" on page 83.
▶
"Resuming BitLocker functionality" on page
93.
▶
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card).
Configuration of network settings should be performed by the
customer. For more information, see "Note on network settings
recovery"
.
▶
If applicable, restore LAN teaming configurations, see "After replacing or
upgrading LAN controllers" on page 101.
9.6.5 Replacing a riser card
Field Replaceable Unit
(FRU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page 45.
▶
If applicable, "Removing the front cover with lock" on page
48.
▶
"Shutting down the server" on page 48.
▶
"Disconnecting the power cord" on page 49.
▶
"Getting access to the component" on page 52.
▶
"Locating the defective component" on page 46.
▶
Remove the corresponding riser module, see "Handling riser modules" on
page 68.
Expansion cards and backup units
232 Upgrade and Maintenance Manual RX2530 M6

Fujitsu PRIMERGY RX2530 M6 Specifications

General

Brand	Fujitsu
Model	PRIMERGY RX2530 M6
Category	Server
Language	English