Fujitsu PRIMERGY RX2530 M6 User Manual

▶
Insert the dummy cover at a slight angle (1). Notice the position of the hook
and the reccess in the chassis (A).
▶
Push the dummy cover in place (2).
▶
Fasten the dummy cover with the knurled screw (3).
Concluding steps
▶
"Connecting the power cord" on page
62.
▶
"Switching on the server" on page
66.
▶
If applicable, "Installing the front cover with lock" on page 66.
9.5.4 Replacing the OCP module
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: tool-less
MAC addresses are stored on the OCP module and are not stored on
the system board. When replacing an OCP module, the MAC addresses
are changed. Inform the customer about that before starting the task.
After doing the task, inform the customer about the changed MAC
addresses.
Preliminary steps
▶
"Locating the defective server" on page 45.
▶
If applicable, "Removing the front cover with lock" on page
48.
▶
"Shutting down the server" on page 48.
▶
"Disconnecting the power cord" on page 49.
Removing the defective OCP module
▶
Remove the OCP module, see "Removing the OCP module" on page 215.
Expansion cards and backup units
216 Upgrade and Maintenance Manual RX2530 M6

Fujitsu PRIMERGY RX2530 M6 Specifications

General

Brand	Fujitsu
Model	PRIMERGY RX2530 M6
Category	Server
Language	English