Fujitsu PRIMERGY RX2530 M6 User Manual

Concluding steps
▶
"Installing the air duct" on page 74.
▶
"Reassembling" on page 57
.
▶
"Connecting the power cord" on page 62.
▶
"Switching on the server" on page 66.
▶
If applicable, "Installing the front cover with lock" on page 66.
▶
"Resuming BitLocker functionality" on page 93.
After replacing memory modules, the Memory Status of them are reset
to Enabled automatically and CSS LED is of
f.
If CSS LED is blinking after they are replaced, check the Memory
Status in the Configuration menu of the BIOS.
10.6 Handling memory dummy modules
It is required to install dummy modules in all empty memory slots. For
example, if two memory modules are installed, the other 30 memory
slots must be equipped with memory dummy modules (32 memory slots
are available).
Removing a memory dummy module
▶
Eject the desired dummy module by pressing out the securing clips at each
end of the memory slot.
▶
Remove the ejected dummy module.
Installing a memory dummy module
▶
Press the securing clips on both sides of the memory slot concerned
outward.
Main memory
276 Upgrade and Maintenance Manual RX2530 M6

Fujitsu PRIMERGY RX2530 M6 Specifications

General

Brand	Fujitsu
Model	PRIMERGY RX2530 M6
Category	Server
Language	English