Chapter 2: Installation and Service Checkout
Service Checkout
2-2 Service Manual
2.2.1.1 Power Cord Condition
To verify the condition of the power cord:
1. Disconnect the power cord from the power outlet.
2. Examine the power cord for signs of damage.
If damage is evident, replace the cord. Do not put in service. Consult authorized service personnel.
3. Verify that the plug retaining brackets for the power cord and the accessory outlets on the back of the
device are placed as shown.
2.2.1.2 Parts
Examine the device overall for any damaged or missing parts.
2.2.1.3 Wheel Operation
To verify wheel operation:
1. Check that all the wheels are in firm contact with the floor and that the device is stable.
2. Lock the wheel brakes by pressing with your foot.
3. Verify that the brakes hold the device in place by trying to move the unit.
If the unit moves, press all brakes again and recheck. If the unit still moves, remove from service.
4. Place your foot under the brake and raise up to unlock it.
5. Move the device by pushing the mounting rails or the depressions on the corners of the device. Verify
that the device moves smoothly.
2.2.1.4 Bed Operation
To verify bed operation:
1. Power on the device as described in “Powering the Device” on page 4-1.
2. Open the two side bed panels and check that they swing all the way down and hang perpendicular to
the bed.
To Next Page
Loading...
Need help?
General
