Cutting 258
cut may not allow the part to be fully drawn on screen before moving onto the next view location.
This may appear as a flashing view screen and may be corrected by zooming out to get a larger view
area.
Speed Increase
Pressing the Speed Increase soft key increases the current cut speed by 3%.
Speed Decrease
Pressing the Speed Decrease soft key decreases the current cut speed by 3%.
Note: The user can also double click the speed field to enter a new speed value
Keyboard operation: To change the current cut speed while cutting a part, press the Enter key once
to highlight the current cut speed, enter in the desired cut speed and press Enter to accept.
Repeats
If a Shape Repeat option has been enabled, you can also see the number of rows and columns
remaining to be cut by pressing the Repeats soft key. The Repeats soft key is shared with the Extend
soft key which is only active during initiation of the cut sequence.
Cut Delay Timers
Cut Delay Timers that define the timing logic for the cut are available for both Oxy-Fuel and Plasma at
the Cut Types setup screen. When in cut mode, the control displays the preset delays as executed in
the lower right corner of the screen. For certain delay times such as Preheat and Pierce, a
continuously updated countdown timer which shows the preset time and time remaining is also
displayed. An example of the Preheat Timer is illustrated below:
To Next Page
Need help?
General
