Password Setups 353
Cut Chart Data Has Changed Message
This message is displayed as a confirmation when it has been detected that the values within the
current Cut Chart screen have changed. This ensures that changes are not made in error when
exiting the screen.
Save Part for Rush Job
This feature will enable or disable the Resume Part prompt for Rush Job Interrupt.
Latched Manual Keys
This parameter will enable or disable the Latched Manual Key feature which allows the manual
motion keys to remain on with a single key press.
Auto Drop Down
When enabled, the Auto Drop Down feature will automatically show the entire list of options at a
selection box.
Zero Positions
This parameter determines whether the control operator has the ability to zero positions. When
disabled, the zero positions softkey will be grayed out and will be unavailable to the operator.
Auto Size App.
When enabled, the Auto Size App. feature is used for the demo software to size the application
software to full screen display or the standard size of 640x480 (disabled).
Language
The language selection parameter allows the user to select the language displayed on the control
from the available languages stored on the control. Languages may be added to the control by
performing the standard software update with a language specific update file. Eastern languages
may also require the installation of a font viewer to properly display the required characters. To
change to a different language, select the desired language and press the OK softkey. You will then
be prompted to cycle power on the control for the new language to be displayed.
Tangent Angle
This parameter is used to set the degree of the tangent angle for control motion. Segments within a
part that intersect at angles greater than the selected tangent angle will decel to zero or minimum
corner speed. Segments within a part that intersect at angles less than or equal to the selected
tangent angle, will not decel unless the next segment is a speed limited arc.
Password
The password parameter allows the user to enter a new password for machine setups. Numbers or
letters may be used.
To Next Page
Loading...
Need help?
General
