Voyager™ III 521
SERCOS Drives Not Enabled and Ready. Please Check Drive are Enabled and Ready with No
Errors.
This status message indicates the SERCOS ring is not running due to a missing enable signal. First
check that the Control Enable Disabled softkey is correct. The softkey should read DISABLE
CONTROL. Then check status of ring hardware or external drives to ensure there are no errors
displayed.
Machine Interface
I/O Configuration Type “V” ( Positive Logic Single Ended I/O )
Connecting single ended I/O to the control. The control provides +24V power on pins 22, 23 & 24
(+24 VDC) and pins 9, 10, 11 &12 (24 VDC Common) on the I/O connector.
Output tied to external Cut On Input tied to Cut Sense Relay
To Next Page
Loading...
Need help?
General
