Overview 21
After zooming out, the display can be zoomed in again by pressing the + key, which causes horizontal
and vertical scroll bars to be displayed. Pressing the - key will zoom back out.
While the scroll bars are displayed and the control is not cutting, the view of the plate can be shifted
horizontally and vertically by pressing and moving the scroll bar or by holding down a shift key and
pressing the arrow keys on the keypad. While the control is cutting, the view will automatically be
shifted as the cut path reaches one of the edges of the view. This mode is useful in normal cutting to
closely follow the cut-path while in zoom.
View Sheet is more useful when proper Plate Size values have been entered in Cutting Setups.
Change Cut Mode
Allows selection of Trial, Oxy Fuel, Plasma, Waterjet and Laser cutting modes, depending on the
setup configuration.
Change Consumable
This soft key takes you to the Change Consumable screen.
Zero Positions
This soft key zeros the current positions on the Transverse and Rail axes as well as the Dual Gantry
axis if used.
To Next Page
Loading...
Need help?
General
