Password Setups 313
speed. Segments within a part that intersect at angles less than or equal to the selected tangent
angle will not decel, unless the next segment is a speed limited arc.
Plasma Hi/Lo Speed Percentage
The Hi/Lo Speed specifies the percentage of the entered Cut Speed below which the control will
activate the Torch Height Disable output. The plasma system may use this output to switch from low
to high current or to disable the height control.
Plasma Distance To Corner
The Plasma Distance to Corner parameter specifies the distance to the corner at which the plasma
system should switch from low current to high current or disable the Automated Height Sensor.
Distance to Corner is active whenever the speed drops below the Plasma Hi/Lo Percentage, or
segments intersect at an angle greater than the tangent angle.
Plasma Distance From Corner
The Plasma Distance from Corner parameter specifies the distance from the corner when exiting, at
which the plasma system should enable the Automated Height Sensor. Distance from Corner is
active whenever the speed drops below the Plasma Hi/Lo Percentage, or segments intersect at an
angle greater than the tangent angle.
To Next Page
Loading...
Need help?
General
