Hypertherm MicroEdge User Manual

Program Codes 417
Program Codes
EIA RS-274D
The control supports EIA RS-274D part programs. An EIA RS-274D program lists the sequence of
Lines, Arcs, Speeds, Kerf and I/O functions used to create a part. While the user is free to program in
EIA using the standard text editor, it is recommended that the ShapeWizard

Graphical Programming
environment be used instead.
Following is a list of the EIA codes that are directly supported, mapped, or currently unsupported by
the control. Mapped EIA codes are automatically converted upon program load into directly
supported EIA codes. Unsupported EIA codes are ignored. All other EIA codes will generate an
error.
Directly Supported EIA Codes
EIA CODE DESCRIPTION
Fvalue Machine Speed (if Speed Override enabled)
Nvalue Line Number
(text) Comments
Xvalue X Axis Endpoint or other Data
Yvalue Y Axis Endpoint or other Data
Ivalue I Axis Integrand or Part Option Data
Jvalue J Axis Integrand or Part Option Data
Ovalue Svalue Output (1-64), State (0-Off or 1-On)
Wvalue Svalue Wait for Input (1-64), State (0-Off or 1-On)
G00 Rapid Traverse Linear Interpolation
G00 Avalue Sets Tilt angle – A is the angle value in degrees
G00 XYval Aval Performs Linear Interpolation of Tilt angle along line segment.
G01 Avalue Fvalue Sets Tilt angle value in degrees with a speed command in RPM
G00 Xn Yn Traverse command where n = value to move the desired axes a distance.
G00 Zx.xx Tx Index Sensor™ THC height “Z” distance for torch “T”. Manual mode only.
G00 Cxx Move to rotate “C” position
G01 Cxx Fxx Move to rotate “C” position with Speed “F” command in RPM
G00 C180- Rotate Axis offset 180 degrees will continue to rotate in the proper direction
G00 C-180- Rotate Axis offset -180 degrees will continue to rotate in the proper direction
G01 C180- Fxx Rotate Axis offset 180 degrees with speed
G01 C-180- Fxx Rotate Axis offset -180 degrees with speed
G01 Linear Interpolation (at Cut Speed)
G02 Clockwise Circular Interpolation
G03 Counterclockwise Circular Interpolation
G04 Preset Dwell (uses Setup Dwell Time)
G04 Xvalue Program Dwell in Seconds
G08 Xvalue Repeat Subroutine X Times
G20 Select English Units (inches)
G21 Select Metric Units (mm)
G40 Disable Kerf Compensation
G41 Enable Left Kerf Compensation
G42 Enable Right Kerf Compensation
G43 Xvalue Kerf Value

Hypertherm MicroEdge Specifications

General

Brand	Hypertherm
Model	MicroEdge
Category	Control Systems
Language	English