Diagnostics 281
I/O
Inputs
This test continuously monitors and displays the current state of all of the optically-isolated discrete
inputs in the control. The current state of each input, On or Off, is displayed to the left of the input
name. Below is an input screen with all of the inputs off.
Inputs displayed with a white background allow for the input name to be changed by the user. To
change the input name, use the Previous/Next arrow key to highlight the desired input and type the
new text for the input name. The input can then be connected to the control and used as
commanded in the part program. Example: The EIA W7 S1 code will pause the program and wait for
input 7 to become active.
A password is required when entering this screen.
Note: The number and name of the Inputs will vary due to control software and hardware
configurations.
To Next Page
Loading...
Need help?
General
