Setups 63
Jog Keys
Selecting the jog keys option allows a directional keypad to be added to the watch window for manual
motion directly from the touch screen. The operator can press the hand ICON in the middle of the
navigation pad to enable manual mode. Select the desired move speed and press the
corresponding arrow for manual motion in the desired direction.
Process Data
The Process Data option allows the user to view up to four selected items for a selected cut or
marking process. Process timers and status items for Oxy Fuel, Plasma, Marker, Waterjet and Laser
may be selected. Note: The process data will only be displayed during the current cut process.
Example: Plasma 1 process parameters will only be displayed in the Watch window at the main cut
screen while cutting in Plasma 1 Mode.
Laser Nozzle
Laser Nozzle consumable life to be graphically displayed while cutting. This is especially useful in
helping to determine when the nozzle should be replaced and keeping track of nozzle data for
statistical process control (SPC).
HPR Power Supply
Allows the user to view status for inputs, outputs and gas pressures for the HPR autogas console.
Up to four power supplies may be monitored. This is generally used for service diagnostics only.
Multiple Watch Windows
Up to ten different Watch windows may be configured on the control for quick selection and viewing of
the Watch icons.
To configure different Watch windows for viewing, first access the Watch setup screen. Press the
number ICON to enter a number or the Left/Right arrows to move up and down through the
selections. The different Watch windows can be selected and viewed during operation using the
same selection process.
To Next Page
Need help?
General
