Automated Plasma Interface 463
Load Data
Pressing the Load Data softkey will allow the operator to Load stored Autogases setting from diskette,
USB memeory or hard drive for use.
If you save the data, a file is created with G59 codes with the selected valve settings. Here is an
example of the data file where all percentages are set to zero.
G59 V65 B0
G59 V66 B0
G59 V67 B0
G59 V68 B0
G59 V69 B0
G59 V70 B0
G59 V71 B0
Test Cutting Gases
Pressing the Test Cutting Gases softkey allows the operator to test the HD3070
®
Cut Gases.
Test Preflow Gases
Pressing the Test Preflow Gases softkey allows the operator to test the HD3070
®
Preflow Gases.
To Next Page
Loading...
Need help?
General
